Botulinum toxin in the restructuring of the face - intradermal technique. What are the practicalities of therapy?
The toxin is injected intradermally with getting hives about 0.3-0.5 cm in diameter, which is less than 0.5 units of onabotulinumtoxinA. Points of injection of frontal muscle in the upper half of the forehead between the eyebrows arch in two to three parallel lines depending on the width of the forehead and active cross lines. Each injection point is approximately 1 cm away from the other.
Injections into the lower half of the face should be along the lines mimic with smaller doses and surface placed to avoid dropping the eyebrows. Forehead, it takes about 5-10 units onabotulinumtoxinA (15-30 sU).
Intradermal technique platizmata for remodeling facial contour in two parallel rows, in temporomandibular joint along the mandible to the mandibular angle and perpendicular to the direction of the fibers of platizmata. Median number is about 1 cm. of the lateral line and injection points are between those of the lateral line. For people with fat submandibularna expressed the need for additional lines in the lower jaw, depending on the width of the face. Platizmata onabotulinumtoxinA dose for both sides is between 20 to 30 units (50-100 sU).
Intradermal technique can be applied to the lateral orbicularis oculi in the lateral edge to soften crow's feet. Can be traced along the wrinkles under the eyes, in the lines caused by repeated frowning and along okoloustnite lines. For all treatments the person using approximately 40-50 U onabotulinumtoxinA (100-150 sU). Injection sites can be modified according to the severity of wrinkles. Repeated treatment may be required in some areas for a more satisfactory result.
No comments:
Post a Comment